Return & Refund
Common Troubleshooting Guide
Reason
- Power supply connection error
- Unstable voltage, below operating voltage
Solution
- Take constant or ACC voltage from car door window regulator
- The power supply voltage needs to be greater than 7.5V
Reason
- One of the RGB colors is short-circuited
Solution
- Check the wiring of the R, G, B color lines, and adjust the independent RGB colors for correctness
Reason
- Sub-control grounding circuit error
Solution
- The grounding position is incorrect, the sub-control is not grounded, and the ground wire of the door connector needs to be connected
Reason
- The button switch is broken
- The phone Bluetooth is not turned on
Solution
- Check if the button switch and wires are disconnected
- Turn on the phone Bluetooth, search for the Bluetooth device name: BT-F1, and connect
- Connect the main controller power red wire to ACC, the black wire to ground, and the yellow wire to the small light or ACC. Connect the power wire of the four-door controller to B+ or ACC, and the black wire to ground.
- Power supply wires: used for connecting to the power source, supplying power to the controller, and controlling the device.
- Left front and rear extension wires: installed on the left side of the car, with one end connected to the controller, and the other two ends connected to the left front and rear door panels.
- Right front and rear extension wires: installed on the right side of the car, with one end connected to the controller, and the other two ends connected to the right front and rear door panels.
- The door handle light and storage box light are installed inside the storage box and at the corresponding position of the door handle inside the car.
- The footwell lights: installed on the main driver and passenger side, as well as on the corresponding decorative panels of the rear footwell.
- The door wiring (light strip wiring) is installed inside the car door. Each door has one wiring, with one end connected to the door extension wire inside the door and the other end connected to the light strip connector.
The final outcome is great but the install is crazy long. Expect 6-10 hours to install the first time. The video is not clear on install. The instructions are as expected … not clear and hard to follow.
For a beginner, this install was a long one in a new 2023 MYP, but well worth the few days it took to complete! It truly does no justice until you see it in person!
I could do again in 2 hrs.
The door lights are trim to fit.
Make sure you have a good stiff thin pry tool (I used a metal one) to get the strips installed on the doors.
I saved time by running the wires outside the rubber tube on the door jamb.
Use a fish tape to pull the wires thru (kit doesn't come with one).
Pretty straight forward but daunting at first.
For the tweeter speakers, pry the front bottom edge upwards and lift up.
Very good, many colors and options.
Hansshow's Model 3/Y ambient lighting is amazing. Available in a variety of colors.